![nucleo f401re development arduino ide nucleo f401re development arduino ide](https://www.analog.com/-/media/analog/en/products/image/measureware/nucleo411-0.jpg)
GPIO_InitDef. GPIO_InitDef.GPIO_Speed = GPIO_Speed_50MHz RCC_AHB1PeriphClockCmd(MW_TFT_RD_CLK, ENABLE) RCC_AHB1PeriphClockCmd(MW_TFT_WR_CLK, ENABLE) 3.4 Select the Nucleo board Select the right Nucleo board F401RE target (fig 4) Figure 4 3.5 Select the right COM port (fig 5) Figure 5 3.6 Compile and flash the Arduino board (fig 6) Figure 6 3.7 Open the serial monitor (fig 7) Figure 7 3. Already designed several shields that work with chipKit UNO32 board by Digilent, but these Nucleo boards caught my eye. I am trying to integrate the Nucleo F401RE board and plan to develop a few shields. RCC_AHB1PeriphClockCmd(MW_TFT_RS_CLK, ENABLE) Here is a low-cost robot that I have been working on. RCC_AHB1PeriphClockCmd(MW_TFT_CS_CLK, ENABLE) Arduino has been quite dominant in the Maker industry for a long period and there have been a number of competitive boards all offering something different, unique and some clone boards. RCC_AHB1PeriphClockCmd(MW_TFT_RST_CLK, ENABLE)
![nucleo f401re development arduino ide nucleo f401re development arduino ide](http://www.sciamannalucio.it/wp-content/uploads/2018/06/portability-of-Arduino-to-STM32-Nucleo-F401RE-pin--300x225.png)
Another bonus is it also comes with a 4 wire resistive touch screen and micro SD card socket.Īs you can see from the pin out the controller uses an 8 bit parallel interface with a further five dedicated control pins. So using my Nucleo development board I started writing a basic driver, something to simply initialise the display and maybe draw some simple test patterns just so I could confirm it was working. The reason I went for this module was that it has a Arduino Uno foot print so should be compatible with the Nucleo development board. The module I purchased allegedly had an SPFD5408 controller fitted. The problem seems to be that sellers are miss stating the controller these modules are fitted with. There seems to be an abundance of posts littered all over the internet regarding these cheap Chinese TFT displays. How to use SPBTLE-RF + NUCLEO-F401RE and graphics GUI How to update FW via GUI on the BlueNRG, BlueNRG-MS or SPBTLE-RF (BlueNRG-MS module) How to use BlueNRG-MS (BTLE v.4. Over the last couple of days I have been somewhat struggling to get a TFT display module I recently purchased from eBay working.